spec no: dsaf2280 rev no: v.1 date: apr/16/2005 page: 1 of 3 approved: j. lu checked: allen liu drawn: y.w.wang erp:11 01007175 description the hyper orange source color devices are made with dh ingaalp on gaas substrate light emitting diode. wp76761csec/e hyper orang e package dimension s 7.6mm x 7.6mm super flux led lamp features super flux output. design for high current operation. outstanding material efficiency. reliable and rugged. rohs compliant. notes: 1. all dimensions are in millimeters (inches). 2. tolerance is 0.25(0.01") unless otherwise noted. 3. lead spacing is measured where the leads emerge from the package. 4. specifications are subject to change without notice.
spec no: dsaf2280 rev no: v.1 date: apr/16/2005 page: 2 of 3 approved: j. lu checked: allen liu drawn: y.w.wang erp:11 01007175 selection guid e electrical / optical characteristics at t a =25 c absolute maximum ratings at t a =25 c notes: 1. 1/10 duty cycle, 0.1ms pulse width. 2. 2mm below package base. 3 . 5mm below package base. symbol parameter device typ. max. test conditions units peak peak wavelength hyper orange 630 nm i f =20ma d dominant wavelength hyper orange 621 nm i f =20ma ? 1/2 spectral line half - width hyper orange 20 nm i f =20ma c capacitance hyper orange 25 pf v f =0v;f=1mhz v f forward voltage hyper orange 2.0 2.5 v i f =20ma i r reverse current hyper orange 10 ua v r = 5v parameter hyper orange units power dissipation 150 mw dc forward current 30 ma peak forward current [1] 195 ma reverse voltage 5 v operating/storage temperature - 40c to +85c lead solder temperature [2] 260c for 3 seconds lead solder temperature [3] 260c for 5 seconds part no. dice lens type iv (mcd) @ 20ma*70ma viewing angle min. typ. 2 ? 1/2 wp76761csec/e hyper orange (ingaaip) water clear 1800 3400 *5700 *10000 20 notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. 2. * luminous intensity with asterisk is measured at 70ma under 40ms pulse width. 3. drive current between 10ma and 30ma are recommended for long term performance. 4. operation at current below 10ma is not recommended.
spec no: dsaf2280 rev no: v.1 date: apr/16/2005 page: 3 of 3 approved: j. lu checked: allen liu drawn: y.w.wang erp:11 01007175 hyper orange wp76761csec/e remarks: if special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. wavelength: +/ - 1nm 2. luminous intensity: +/ - 15% 3. forward voltage: +/ - 0.1v note: accuracy may depend on the sorting parameters.
|
